4x4 1T front suspension bushing replacement

mjeltema · 06-26-2008, 10:54 AM

Have a 1996 k3500 6.2l diesel 4x4 that needs the front suspension bushings replaced. Specifically, the bushings that the caster/camber adjustment bolts go through, need to be replaced. Does anyone have the correct procedure to replace these bushings and are any special tools required to complete the job?

75K30 · 06-26-2008, 11:13 AM

This is a pretty straigh foward job, and the only thing to look out for would be the pre-load on the torsion bars. You will have to find a way to get these off (easy part) and then get the keys back on (little more difficult).
Just be sure not to damage the control arm when pressing the old bushings out.
The rest is pretty typical.

06-26-2008, 10:54 AM	#1
mjeltema Junior Member Join Date: Dec 2006 Posts: 6	4x4 1T front suspension bushing replacement Have a 1996 k3500 6.2l diesel 4x4 that needs the front suspension bushings replaced. Specifically, the bushings that the caster/camber adjustment bolts go through, need to be replaced. Does anyone have the correct procedure to replace these bushings and are any special tools required to complete the job?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
front suspension	14483jack	Chevy Truck Forum	1	05-10-2007 09:02 PM
Front suspension troubles	Steve T.	Chevy Truck Forum	3	03-29-2007 01:20 PM
control arm bushing replacment	4x4hover	Chevy Truck Forum	5	02-15-2007 12:09 PM
Dodge Front End Replacement	thsboss99	Truck Classifieds	0	11-26-2006 07:23 PM
Suspension Lift problem with front shocks	metafizx	Toyota Truck Forum	1	09-14-2006 11:46 AM

06-26-2008, 11:13 AM	#2
75K30 Senior Member Join Date: Jul 2006 Posts: 2,545	This is a pretty straigh foward job, and the only thing to look out for would be the pre-load on the torsion bars. You will have to find a way to get these off (easy part) and then get the keys back on (little more difficult). Just be sure not to damage the control arm when pressing the old bushings out. The rest is pretty typical.